LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. With an assistant, align the hinge to the alignment marks made with the grease pencil.
  2. Fig 1: Vehicle Hinge Fasteners
    GM838512Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the fasteners (1) retaining the hinge to the vehicle.
  4. Fig 2: Rear Door Hinge Fasteners
    GM838521Courtesy of GENERAL MOTORS CORP.
  5. Install the fasteners (1) retaining the hinge to the door.

    Tighten:  Tighten the fasteners to 25 N.m (18 lb ft).

  6. Adjust the door if necessary. Refer to Rear Door Adjustment .