LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement .
  3. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
  4. With the key installed hold it in the START position.
    5. Fig 1: View Of Lock Cylinder & Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  5. Install an allen wrench into the hole on top of the ignition lock cylinder case.

    Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.

    6. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  6. Slide the ignition lock cylinder out of the ignition lock cylinder case.
scientia non olet · About LEMON Manuals