LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Lever Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Remove the left side hinge pillar panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  4. Remove the MID-Bussed Electrical Center from the bracket.
    5. Fig 1: Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the park brake warning lamp connection.
    6. Fig 2: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the park brake release cable from the park brake lever.
    7. Fig 3: Park Brake Lever Mounting Nuts
    GM793126Courtesy of GENERAL MOTORS CORP.
  7. Remove the park brake lever mounting nuts.
    8. Fig 4: Front Brake Cable & Park Brake Lever
    GM913310Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the front park brake cable from the park brake lever.
  9. Remove the park brake lever.
scientia non olet · About LEMON Manuals