LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Cover and Pad Replacement >> Installation Procedure

Installation Procedure

  1. Working from side to side, carefully install the seat back cover over the foam pad.
    2. Fig 1: Rear Seat Back Components
    GM276555Courtesy of GENERAL MOTORS CORP.
  2. Remove the cardboard from between the seat back cover and the foam pad.
  3. Engage the hook, and the loop strips that retain the seat back cover (2).
  4. Engage the J-clips that retain the seat back cover.
  5. Install the seat back plastic cover (10) to the seat back frame, if equipped.
  6. Install the head restraints (1) to the seat back. Refer to Head Restraint Replacement .
  7. Install the armrest to the seat back, if removed. Refer to Rear Seat Armrest Replacement .
  8. Install the seat back folding cover, if removed. Refer to Rear Folding Seat Back Cover Replacement .
  9. Install the rear seat to the vehicle. Refer to Rear Seat Replacement .
scientia non olet · About LEMON Manuals