LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Rear Side Door Window Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Door Window
    GM838833Courtesy of GENERAL MOTORS CORP.
  1. Slide the window through the opening of the window frame into position in the window clamps (1).
  2. Install the sealing strip. Refer to Rear Door Window Belt Outer Sealing Strip Replacement .
    3. NOTE: Refer to Fastener Notice .
  3. Install the run channel. Refer to Rear Side Door Window Channel Replacement .

    Tighten:  Tighten the clamps to 9 N.m (6 lb ft).

  4. Install the stabilizer. Refer to Rear Side Door Window Stabilizer Replacement .
  5. Operate the window to ensure proper operation.
  6. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  7. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals