LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers And Fascias >> Repair Instructions >> Front Bumper Replacement >> Installation Procedure

Installation Procedure

  1. Install the front bumper assembly to the vehicle.
    2. Fig 1: Front Bumper Assembly
    GM815435Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the 2 upper bolts to the bumper bar.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

  3. Connect the electrical connector to the DRL.
    4. Fig 2: View Of Fascia Plugs
    GM1453827Courtesy of GENERAL MOTORS CORP.
  4. Install the 2 plugs (1) to the front fascia (2).
    5. Fig 3: Bumper Bar Bolts
    GM815434Courtesy of GENERAL MOTORS CORP.
  5. Install the 2 lower bolts to the bumper bar.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

    6. Fig 4: Grille & Brush Guard
    GM824708Courtesy of GENERAL MOTORS CORP.
  6. Install the front grille guard, if equipped. Refer to Grille Guard/Brush Guard Replacement (Base) or Grille Guard/Brush Guard Replacement (WS2, V3M) .
scientia non olet · About LEMON Manuals