LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  3. Disconnect the speaker electrical connector.
  4. Disconnect the window motor electrical connector.
  5. Disconnect the door lock actuator electrical connector.
  6. Remove the wiring harness from door through the pass through hole (2) by releasing all retainers, noting their location for reinstallation.
    7. Fig 1: Rear Door Wiring Harness
    GM893297Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the door harness from the body harness (2).
scientia non olet · About LEMON Manuals