LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Rear Side Door Outside Handle Replacement >> Installation Procedure

Installation Procedure

  1. Position the door handle in place on the door.
  2. Apply a piece of masking tape across the door handle on the outside of the door to secure the door handle while installing the fasteners.
    3. Fig 1: Rear Outside Door Handle
    GM838687Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the 3 nuts (1) that retain the door handle to the door.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

    4. Fig 2: Rear Outside Door Handle Rod
    GM838683Courtesy of GENERAL MOTORS CORP.
  4. Connect the outside door handle rod (1) by securing the retention clip (2).
  5. Operate the door handle to ensure proper operation.
  6. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  7. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals