LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Cellular, Entertainment, And Navigation >> Repair Instructions >> Radio Antenna Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Antenna Mast, Antenna Mast Boot, Intake Air Duct Screws
    GM1440885Courtesy of GENERAL MOTORS CORP.
  1. Push the antenna mast boot (2) up in order to access the antenna mast (1) for removal.
  2. Remove the antenna mast (1).
  3. Remove the intake air duct screws (3).
  4. Remove the intake air duct.
    5. Fig 2: Antenna Base Screws, Antenna Base
    GM1440896Courtesy of GENERAL MOTORS CORP.
  5. Remove the antenna base screws (1).
  6. Remove the right body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
  7. Disconnect the antenna base/cable from the instrument panel (I/P) extension cable.
    8. IMPORTANT: Attach a piece of mechanics wire or string to the antenna cable before the cable is removed from the body to ease installation and ensure proper routing after the cable/antenna base is replaced.
  8. Attach a piece of wire or string to the antenna cable end at the kick panel.
  9. Remove the antenna cable/base (2) from the vehicle, leave the mechanics wire or string with the body.
scientia non olet · About LEMON Manuals