LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Rear Seat Replacement (Crew Cab with A68)

Rear Seat Replacement (Crew Cab with A68)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seat (Crew Cab with A68)
GM1814244Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the rear center seat belt anchor nut. Refer to Seat Belt Replacement - Center Rear (Crew Cab) or Seat Belt Replacement - Center Rear (Extended Cab) .
1 Rear Seat Assembly Nut (Qty: 6)
NOTE: Refer to Fastener Notice .

Tip:  Fold the rear seat cushion up to access the nuts.

Tighten:  50 N.m (37 lb ft)
2 Rear Seat Assembly
Tip: 
  1. Split the rear seats if only one seat is to removed at a time. Refer to Rear Seat Separation (Extended Cab w/A68) .
  2. Lift the seat assembly upward to release the rear seat back hooks from the rear of the cab.
scientia non olet · About LEMON Manuals