Conditions for Clearing the MIL/DTC

The DTC becomes history when the conditions for setting the DTC are no longer present.
A history DTC is cleared after 40 consecutive malfunction free warm-up cycles.
The PCM receives the clear code command from the scan tool.

DTC P0654

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Install a scan tool. Start the engine. With the scan tool, observe the Engine Speed parameter in the PCM Engine Data 1 data list. Does the Engine Speed parameter match the tachometer display?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Turn the ignition OFF. Disconnect the powertrain control module (PCM) connector C2. Install one J 33431-C Signal Generator and Instrument Panel Tester lead to the engine speed signal circuit at the PCM harness connector, and connect the other lead to a good ground. See Special Tools . Turn the ignition ON, with the engine OFF. Set the J 33431-C to generate a tachometer signal. See Special Tools . Does the vehicle tachometer indicate an RPM reading?	Go to Step 5	Go to Step 4
4	Test the engine speed signal circuit for a short to voltage or for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 6
5	Inspect for poor connections at the PCM connector. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Inspect for a poor connection at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 8
7	Replace the PCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
8	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 9	-
9	Use the scan tool in order to clear the DTCs. Operate vehicle within the Conditions for Running this DTC. Does the DTC reset?	Go to Step 2	System OK