LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2005 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Diagnostic Information And Procedures >> Change Engine Oil Indicator Always On

Change Engine Oil Indicator Always On

Change Engine Oil Indicator Always On

Step Action Yes No
Schematic Reference:  Instrument Cluster Schematics  
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 Start the engine.
Does the CHANGE ENGINE OIL indicator illuminate in the Driver Information Center?		 Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Install a scan tool.
  2. With the scan tool, observe the Engine Oil Life Remaining parameter in the PCM Engine Data 2 data list.
Does the Engine Oil Life Remaining parameter display 0%?		 Go to Step 4  Go to Step 5 
4 Reset the engine oil life. Refer to GM Oil Life System - Resetting in Maintenance and Lubrication.
Does the CHANGE ENGINE OIL indicator turn off?		 Go to Step 6  Go to Step 5 
5 Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
scientia non olet · About LEMON Manuals