Backup Lamps Inoperative

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Body Control System Connector End Views in Body Control System
1	Did you perform the Lighting Systems Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Verify that the backup lamps are inoperative. Do the backup lamps operate normally?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Is only one backup lamp inoperative?	Go to Step 5	Go to Step 4
4	Use the scan tool to check if there are any codes set in the current or history Powertrain DTC Information. Are any codes present?	Go to the Diagnostic System Check in the appropriate Transmission Section	Go to Step 6
5	Test the backup lamp supply voltage and ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct a condition?	Go to Step 10	Go to Step 8
6	Test the backup lamp supply voltage and ground circuit for an open or high resistance or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct a condition?	Go to Step 10	Go to Step 7
7	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 10	Go to Step 9
8	Replace the affected backup lamp bulb. Refer to Tail/Turn Signal Lamp Replacement (SUV) . Did you complete the replacement?	Go to Step 10	-
9	IMPORTANT: Perform the setup procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?	Go to Step 10	-
10	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3