DTC U3000-51 (Head Up Display): Notes

DTC U3000-51  : Reprogramming error

How to use this manual .

NOTICE:  

Before you troubleshoot, review the How to Troubleshoot .

NOTE: 

• If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks () or Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode B - Control Unit Not Communicating () or Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode 1 and Test Mode 2 (without the HDS) () .
• Before reprogramming the head up display, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a 12 volt battery charger) to maintain system voltage.
• Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, during the reprogramming. If there is a problem with the reprogramming, turn the vehicle to the ON mode.