Front Passenger's Airbag Removal and Installation: Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: How to read the torque specifications .

Installation Before the Front Passenger's Airbag Deployment 

1. Front Passenger's Airbag - Install

   Courtesy of HONDA, U.S.A., INC.

   1. Insert the hooks (A) into the front passenger's airbag housing holes (B). NOTE:  Make sure there are no objects between the airbag and the dashboard. Make sure the airbag is fully seated, and make sure the dashboard is not deformed or damaged after the airbag is in place. Make sure the hooks are set properly. 2. Tighten the new mounting bolts (C, D).

   Courtesy of HONDA, U.S.A., INC.

   3. Connect the connector (A).

2. SRS Operation - Confirm

   1. Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

3. Blower Unit - Install

   Installation After the Front Passenger's Airbag Deployment 

4. Front Passenger's Airbag - Install

   Courtesy of HONDA, U.S.A., INC.

   1. Insert the hooks (A) of the front passenger's airbag into the housing holes (B). NOTE:  Make sure there are no objects between the airbag and the dashboard. Make sure the airbag is fully seated, and make sure the dashboard is not deformed or damaged after the airbag is in place. Make sure the hooks are set properly. 2. Tighten the new bolts (C).

5. Front Passenger's Airbag/Dashboard - Install
6. Front Passenger's Airbag Inflator Connector - Connect

   Courtesy of HONDA, U.S.A., INC.

   1. Connect the connector (A).

7. SRS Operation - Confirm

   1. Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

8. Glove Box - Install