Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. 12 Volt Battery Terminal - Disconnect

   NOTE:  Wait at least 3 minutes before starting work.

2. Climate Control panel / Front Passenger's Airbag Cutoff Indicator - Remove
3. All Removed Parts - Install

   1. Install the all removed parts in the reverse order of removal.

4. SRS Operation - Confirm

   1. Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.