ACC indicator (on the MID) does not go off, and no DTCs are stored

WARNING: This page is about a different variant/trim than selected.

Diagnostic procedure

NOTE: If any of the CAN communication failure DTC is indicated in another system, troubleshoot the DTC first.

Check for an open or a short in the F-CAN circuit;
- -
  Between the gauge control module and the CAN gateway (F-CAN D_H, F-CAN D_L)
- -
  Between the millimeter wave radar and the CAN gateway (F-CAN C_H, F-CAN C_L)
Check the millimeter wave radar power circuit (IG1_OPTION).
Check the millimeter wave radar ground circuit (GND).
Do to the gauge control module self-diagnostic function .

Also check for

Refer to the followings about the indicator operating condition;

Refer to the followings about the circuit troubleshooting;