LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2021 >> CR-V EX-L, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (VSA System - DTC Diagnostics (2 Of 2) (Hybrid)) >> DTC Troubleshooting >> DTC P0CF0 (1063)

DTC P0CF0 (1063)

WARNING: This page is about a different variant/trim than selected.

DTC P0CF0  : PCU Coolant Temperature Sensor Circuit Low

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC Description Confirmed DTC Pending DTC Freeze Frame
P0CF0 PCU Coolant Temperature Sensor Circuit Low      

DTC (Electric Powertrain)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Turn the vehicle to the OFF (LOCK) mode.

    -4. Turn the vehicle to the ON mode.

    -5. Check the parameter(s) below with the HDS.

    Signal Threshold Current conditions
    Values Unit Values Unit
    PCU Coolant Temperature Sensor Voltage (TRC) Less than 0.08 V    

    Does the current condition(s) match the threshold?

    YES 

    The failure is duplicated. Go to step 2.

    NO 

    Intermittent failure. The system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

  2. Determine possible failure area ((TWPCU/PCU_TW_SNSR line, PCU coolant temperature sensor)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Disconnect the following connector.

    PCU coolant temperature sensor 2P connector

    -3. Turn the vehicle to the ON mode.

    -4. Check the parameter(s) below with the HDS.

    Signal Threshold Current conditions
    Values Unit Values Unit
    PCU Coolant Temperature Sensor Voltage (TRC) About 5.0 V V    

    Does the current condition(s) match the threshold?

    YES 

    Replace the PCU coolant temperature sensor .

    NO 

    The PCU coolant temperature sensor is OK. Go to step 3.

  3. Shorted wire check (TWPCU/PCU_TW_SNSR line)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Do the 12 volt battery terminal disconnection procedure .

    -3. Disconnect the following connector.

    PCU 33P connector

    -4. Measure the resistance between test points 1 and 2.

    Test condition Vehicle OFF (LOCK) mode
      PCU 33P connector: disconnected
      PCU coolant temperature sensor 2P connector: disconnected
    Test point 1 PCU 33P connector No. 16
    Test point 2 Body ground

    Is there 1 MΩ or more?

    YES 

    Replace the PCU .

    NO 

    Repair a short in the TWPCU/PCU_TW_SNSR wire between the PCU coolant temperature sensor and the PCU.