DTC P0C4E (93)
WARNING: This page is about a different variant/trim than selected.
DTC P0C4E : Traction Motor Rotor Position Exceeded Learning Limit
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0C4E Traction Motor Rotor Position Exceeded Learning Limit |
DTC (Electric Powertrain)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode.
-5. Do the traction motor motor rotor position calibration .
Is calibration completed?
YES
Intermittent failure. The system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
NO
Faulty traction motor motor rotor position sensor. Replace the transmission (e-CVT) assembly .