DTC P0A3F (89), P0A40 (197), P0A41 (198)
DTC P0A3F : Traction Motor Rotor Position Sensor Circuit
DTC P0A40 : Traction Motor Rotor Position Sensor Circuit Range/Performance
DTC P0A41 : Traction Motor Rotor Position Sensor Circuit Low
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0A3F Traction Motor Rotor Position Sensor Circuit | |||
| P0A40 Traction Motor Rotor Position Sensor Circuit Range/Performance | |||
| P0A41 Traction Motor Rotor Position Sensor Circuit Low |
DTC (Electric Powertrain)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode.
-5. Monitor the OBD STATUS for DTC P0A3F, P0A40, and P0A41 in the DTCs MENU with the HDS.
DTC Description OBD STATUS P0A3F Traction Motor Rotor Position Sensor Circuit P0A40 Traction Motor Rotor Position Sensor Circuit Range/Performance DTC Description OBD STATUS P0A41 Traction Motor Rotor Position Sensor Circuit Low Does the HDS indicate FAILED?
YES
The failure is duplicated. Go to step 2.
NO
If the HDS indicates PASSED, the system is OK at this time but has an intermittent failure. If the HDS indicates NOT COMPLETED, keep the vehicle in the ON mode until the status changes. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
- Traction motor motor rotor position sensor circuit check
-1. Do the traction motor motor rotor position sensor circuit inspection .
Is it OK?
YES
The traction motor motor rotor position sensor circuit is OK. Faulty traction motor motor rotor position sensor. Replace the transmission (e-CVT) assembly .
NO
Repair an open or short in the traction motor motor rotor position sensor circuit between the PCU and the traction motor motor rotor position sensor.