SRS Symptom Troubleshooting - Front seat belt reminder indicator does not come on, turn off, or flash
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
- DTC check
-1. Check for DTCs with the HDS.
DTC Description DTC Are any SRS DTCs indicated?
YES
Go to SRS DTC troubleshooting.
NO
Go to step 2.
- Body electrical system DTC check
-1. Check for body electrical DTCs with the HDS.
DTC Description DTC U0151-00 Gauge control module lost communication with SRS unit Is DTC U0151 indicated?
YES
Go to DTC U0151 troubleshooting .
NO
Go to step 3.
- Gauge control module check
-1. Do the gauge control module self-diagnostic function .
Self diagnostic function - CAN METER
Does the front seat belt reminder indicator blinkΩ
YES
Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .
NO