Engine does not start (CVT: With Auto Idle Stop System)
WARNING: This page is about a different variant/trim than selected.
Probable cause (s)
- Shift cable broken or out of adjustment
- Control pin broken
- Transmission range switch defective or out of adjustment
- Drive plate worn or damaged
- Torque converter assembly defective
- Torque converter ring gear worn or damaged
- Transmission assembly and drive plate installation defective
NOTES:
- Check for a loose shift cable at the shift lever and the control lever .
- Inspect the transmission range switch .
- Inspect the drive plate for wear and damage. If the drive plate is worn or damaged, replace it .
- Inspect the torque converter assembly for wear and damage. If the torque converter assembly is worn or damaged, replace it as an assembly .