Auxiliary Transmission Fluid Pump Air Bleeding (CVT: With Auto Idle Stop System): Bleeding
WARNING: This page is about a different variant/trim than selected.
NOTE: The auxiliary transmission fluid pump air bleeding procedure must be done when:
- The auxiliary transmission fluid pump is removed.
- The transmission fluid is replaced.
- The TCM is replaced. If you replace the TCM, you must done Procedure After Replacing TCM.
Procedure With HDS
- HDS - Connect
- Transmission Fluid Level - Check
- Engine - Warm Up
1. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on twice). 2. Turn the engine off.
- Auxiliary Transmission Fluid Pump - Air Bleed
1. Select the Electrical Oil Pump Activation in the Function Test Menu, and drive the auxiliary transmission fluid pump for at least 15 seconds with the HDS.
NOTE: Do not drive the auxiliary transmission fluid pump for more than 160 seconds at a time. - Transmission Fluid Level - Check
Procedure Without HDS
- Transmission Fluid Level - Check
- Engine - Warm Up
1. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on twice). - Auxiliary Transmission Fluid Pump - Air Bleed
1. Do the auto idle stop system operation . If the auto idle stop system does not operate for at least 15 seconds, repeat this procedure and recheck, or do the procedure with HDS. - Transmission Fluid Level - Check
Procedure After Replacing TCM
- Auxiliary Transmission Fluid Pump - Air Bleed
NOTE: - Do not start the engine.
- Do not remove the battery and fuse.
1. Turn the vehicle to the ON mode, then wait at least 2 seconds.
2. Turn the vehicle to the OFF (LOCK) mode, then at least 10 seconds.
3. Turn the vehicle to the ON mode.
4. Check that the shift position indicator does not blink. If shift position indicator blinks, repeat step 1.
- Transmission Fluid Level - Check