LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2020 >> Fit EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Sunroof - Roof Opening Panel - Vehicles With: Panoramic Roof Opening Panel (Except Hybrid)) >> General Procedures >> Roof Opening Panel Alignment

Roof Opening Panel Alignment

WARNING: This page is about a different car, the 2015 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.

Adjustment 

  1. 1.

    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT HYBRID) . Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions .

  1. 2.

    Measure the front and rear of the roof opening panel glass to trim panel clearances and the front of the roof opening panel glass to trim panel clearances as shown in illustration.
GFD104761Courtesy of FORD MOTOR COMPANY

  1. 3.

    1. 1.

      To adjust front up or down, loosen bolt 1 only.

    1. 2.

      To adjust front gap, loosen bolt 1 and bolt 2.

    1. 3.

      To adjust rear up or down, loosen bolt 3 only.

    1. 4.

      Adjust as necessary.

      Torque

      : 53 lb.in (6 Nm)

GFD104762Courtesy of FORD MOTOR COMPANY

  1. 4.

    Initialize the power roof opening panel. REFER to: Power Roof Opening Panel Initialization  - Vehicles With: Panoramic Roof Opening Panel.