Power Roof Opening Panel Initialization
WARNING: This page is about a different car, the 2015 Lincoln MKZ. However, it is still accessible from the selected car via links, so may be relevant.
Initialization
WARNING:
Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.
NOTE:
A new roof opening panel must be initialized after installation. Until the drive assembly has been initialized, the express open and close switch inputs are disabled.
NOTE:
The roof opening panel initialization procedure must be done when repairs are carried out on any part of the roof opening panel system, or when excessive false reversals are experienced.
NOTE:
If the roof opening panel glass is very close to proper alignment specifications, this procedure may align the glass.
- 2.
Close all doors and position the ignition switch ON, engine OFF. If the map lamps are on, wait for the map lamps to turn off before proceeding.
- 3.NOTE: Perform steps 3 - 4 within 4 seconds.
Press and release the left map lamp switch turning it on.
- 5.
Press and release the left map lamp switch. The right map lamp will turn on and then off. As soon as the right map lamp turns off, press and release the left map lamp switch again.
- 6.NOTE: This step may take up to 15 seconds.
Press and hold the glass CLOSE switch until the sliding glass moves to the front hard stop and returns to fully closed, followed by an audible click (relay switching sound), and then release the switch.
- 7.
Within 5 seconds of releasing the switch in the previous step, press and hold the glass CLOSE switch until the shade and sliding glass fully open and then fully close, and then release the switch.