DTC: C1C22-62 (2019 2020 2021)

DTC C1C22-62  : Neutral Sensor Failure

NOTE: Before You Troubleshoot, Review The General Troubleshooting Information .

DTCs (VSA)

1. DTC check

   -1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   - 3. Turn the vehicle to the OFF (LOCK) mode.

   - 4. Test-drive the vehicle at 19 mph (30 km/h) or more for 60 seconds or more.

   NOTE:  Drive the vehicle on the road, not on a lift.

   - 5. Check for DTCs with the HDS.

   DTC Description	DTC
   U0029-00 CAN Communication Failure (Bus OFF Ch 1)
   U0101-00 CAN Communication Failure with PCM/TCM
   C1C22-62 Neutral Sensor Failure

   Is DTC C1C22-62 indicated?

   YES 

   If DTC C1C22-62 is only indicated, go to step 2.

   YES 

   If DTC U0029-00 or U0101-00 are also indicated, go to U0101-00 - Refer to:

   U0029-00  or

   DTC Troubleshooting: U0100-00, U0101-00, U0101-00, U0104-00, U0126-00, U0155-00 (VSA Control Unit: 6-Speed A/T) (2016 2017 2018)  or

   DTC Troubleshooting: U0100-00, U0101-00, U0126-00, U0155-00 (VSA Control Unit: 6-Speed A/T [Without CAN Gateway]) (2019 2020 2021)  or

   DTC Troubleshooting: U0100-00, U0101-00, U0101-00, U0104-00, U0126-00, U0155-00 (VSA Control Unit: 6-Speed A/T [With CAN Gateway]) (2019 2020 2021)  or

   DTC Troubleshooting: U0100-00, U0101-00, U0101-00, U0104-00, U0126-00, U0155-00 (VSA Control Unit: 9-Speed A/T) (2016 2017 2018)  or

   DTC Troubleshooting: U0100-00, U0101-00, U0126-00, U0155-00 (VSA Control Unit: 9-Speed A/T [Without CAN Gateway]) (2019 2020 2021)  or

   DTC Troubleshooting: U0100-00, U0101-00, U0101-00, U0104-00, U0126-00, U0155-00 (VSA Control Unit: 9-Speed A/T [With CAN Gateway]) (2019 2020 2021) .

   NO 

   Intermittent failure, the system is OK at this time. Refer To Intermittent Failures Troubleshooting .

2. A/T system parameter check

   -1. Check the parameter(s) below with the HDS.

   Signal	Current conditions
   	Values	Unit
   A/T N Switch

   Does the parameter change when shifting the transmission to N position/mode, or shifting from the N position/mode to a different gear position other than reverse?

   YES 

   Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA Modulator-Control Unit. Refer to:

   Replace The VSA Modulator-Control Unit .

   NO 

   Check The A/T System DTC .