Secondary Shaft ATF Feed Pipe Cap, Feed Pipe Replacement

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The 1st-hold clutch ATF feed pipe/ATF feed cap is not available separately.

Remove the ATF feed pipe cap from the transmission housing (see SECONDARY SHAFT ATF FEED PIPE CAP REMOVAL ).
Remove the snap ring (A) from the feed pipe cap (B), then remove the feed pipe guide (C), the O-rings (D) (E), and the 1st clutch ATF feed pipe (F).

Fig 1: Identifying Snap Ring, Feed Pipe Cap, Feed Pipe Guide, O-Rings And 1st Clutch ATF Feed Pipe
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace the 1st clutch ATF feed pipe or 1st-hold clutch ATF feed pipe/ATF feed pipe cap assembly.
Install a new O-ring (E) over the 1st clutch ATF feed pipe, then install the feed pipe over the 1st-hold clutch ATF feed pipe (G) while aligning the feed pipe tabs (H) with the guide in the cap.
Install a new O-ring (D) in the cap and the feed pipe guide, then secure the guide with the snap ring.
Install the ATF feed pipe cap in the transmission housing (see SECONDARY SHAFT ATF FEED PIPE CAP INSTALLATION ).