LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2017 >> Odyssey SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transmission - 5-Speed) >> Shafts and Clutches >> 1st Gear One-Way Clutch Inspection

1st Gear One-Way Clutch Inspection

WARNING: This page is about a different car, the 2013 Honda Odyssey, 2012 Honda Odyssey, and 2011 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Hold the 1st-hold clutch hub (A), and turn 1st gear (B) in the direction shown to be sure it turns freely. Also make sure 1st gear locks in the opposite direction.
    Fig 1: Inspecting 1st Gear One-Way Clutch
    G06967245Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. If any problem occurs on the 1st gear one-way clutch, replace the 1st clutch hub (C). The 1st gear one-way clutch is not available separately from the 1st clutch hub.
  3. Also check 1st gear arid the 1st-hold clutch hub for wear and damage. If 1st gear and the 1st-hold clutch hub are worn or damaged, replace the damaged part, refer to 1ST CLUTCH HUB REPLACEMENT  .
scientia non olet · About LEMON Manuals