LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2016 >> Odyssey EX >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating/Air Conditioning >> Front Power Transistor Test

Front Power Transistor Test

  1. Remove the passenger's dashboard undercover (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
  2. Disconnect the 5P connector from the front power transistor.
  3. Measure the resistance between terminals No. 3 and No. 5 of the front power transistor. It should be about 1.5 kΩ.
    • If the resistance is within the specifications, go to step 4.
    • If the resistance is not within the specifications, replace the front power transistor.
      NOTE: Also check the front blower motor. Front power transistor failure can be caused by a defective front blower motor.
      Fig 1: Measuring Resistance Between Terminals No. 3 And No. 5 Of Front Power Transistor
      G06968179Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Reconnect the 5P connector to the front power transistor.
  5. Disconnect the HVAC control unit 28P connector.
  6. Connect HVAC control unit 28P connector terminals No. 1 and No. 10 with a jumper wire.
    Fig 2: Identifying Jumper Wire Connection Between HVAC Control Unit 28P Connector Terminal No. 1 And Body Ground
    G06968180Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Turn the ignition switch to ON (II), and check that the front blower motor runs.
    • If the front blower motor does not run, replace the front power transistor.
      NOTE: A faulty front blower motor can cause the front power transistor to fail. Before replacing the front power transistor, check the front blower motor for binding, and replace it if necessary.
    • If the front blower motor runs, the front power transistor is OK.
scientia non olet · About LEMON Manuals