Passenger's Dashboard Undercover Removal/Installation

NOTE: Take care not to scratch the dashboard or the related parts.

Remove the passenger's dashboard undercover (A).
1. Gently pull down the rear edge of the undercover to detach the clips (B, C).
2. For some models: Disconnect the passenger's footwell light connector (D).
3. Pull out the undercover to release the projections (E) from the holders (F).
  
  Fig 1: Identifying Passenger's Dashboard Undercover, Passenger's Footwell Light Connector, Holders And Clips
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- For some models: Make sure the connector is plugged in properly.
- Make sure the projections of the undercover are installed securely to the holders.
- Push the clips into place securely.