LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Front Impact Sensor Replacement >> Removal

Front Impact Sensor Replacement: Removal

  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the front inner fender (see FRONT INNER FENDER REPLACEMENT ).
  3. Disconnect the left or right front impact sensor 2P connector (A).
    Fig 1: Identifying Left Or Right Front Impact Sensor 2P Connector, TORX Bolt And Front Impact Sensor
    G06952563Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the TORX bolt (B) using a TORX T30 bit, then remove the front impact sensor (C).
scientia non olet · About LEMON Manuals