Clutch Pedal Pad Cover Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE: This procedure is for models equipped with a clutch pedal pad cover.

Cover the carpet under the clutch pedal to prevent metal shavings from getting on the carpet.
Center-punch each of the rivets (A), and drill their heads off with a 3 mm (0.12 in) drill bit (B).
NOTE: Do not drill the clutch pedal pad (C).

Fig 1: Identifying Clutch Pedal Pad, Rivets And Drill Bit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the clutch pedal pad cover (A) and the clutch pedal cover (B) from the clutch pedal pad (C).

Fig 2: Identifying Clutch Pedal Pad Cover With Clutch Pedal Pad
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Set the clutch pedal cover to the clutch pedal pad cover.
Install the clutch pedal pad cover (A) with the rivets (B) firmly.

Fig 3: Identifying Clutch Pedal Pad Cover With Rivets
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Using your hand, make sure the clutch pedal cover is firmly fastened to the pedal.
Check the clutch pedal height (see CLUTCH PEDAL AND CLUTCH PEDAL POSITION SWITCH ADJUSTMENT ).