LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Gauges >> Resetting the Lifetime Points

Resetting the Lifetime Points

NOTE:
  • Do steps  1 through  5 within 30 seconds.
  • If the ambient meter color is set to always display blue with the custom setting, cancel that setting by following the instructions in the Owner's Manual.
  1. Turn the ignition switch to ON (II).
  2. Confirm that the NORMAL mode or SPORT mode by the multi-information display (MID) or indicator.
    NOTE: If the ECON system is in the ECON mode, change it to the NORMAL mode or SPORT mode by pressing the NORMAL mode switch or SPORT mode switch, then turn the ignition switch to LOCK (0), then repeat this step again.
  3. Press and release the brake pedal at least twice.
  4. Confirm that the ambient meter color is green.
    NOTE: If the ambient meter color is set to always be blue with the custom setting, it will not change to green.
  5. Press the ECON mode switch once, then press the SPORT mode switch or NORMAL mode switch once.
  6. Confirm that the ambient meter color disappears.
    NOTE: If the ambient meter color is set to always be blue with the custom setting, it does not disappear.
  7. Turn the ignition switch to LOCK (0).
    NOTE: The Eco score and the Eco stage indicator are not displayed unless you let the engine idle for 3 minutes or drive for at least 218 yards (200 m).
scientia non olet · About LEMON Manuals