Repair and Diagnosis: Electrical: Gauges: Gauges
- Component Location Index
- System Description
- Self-Diagnostic Function
- Notes
- Entering the Self-Diagnostic Function With the HDS
- Entering the Self-Diagnostic Function (Manual method)
- The Indicator Drive Circuit Check
- The Ambient Meter Color Variation Check
- The Beeper Drive Circuit Check
- Switch Input Check
- The Multi-Information Display (MID) Check
- The Gauge Drive Circuit Check
- The Communication Line Check
- Ending the self-diagnostic function
- Circuit Diagram
- DTC Troubleshooting
- DTC B1152: Gauge Control Module Internal (EEPROM) Error
- DTC B1175: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Malfunction
- DTC B1176: Fuel Level Sensor (Fuel Gauge Sending Unit) Circuit Short
- DTC U0029: F-CAN Communication Line Error
- DTC U0100: Gauge Control Module Lost Communication With ECM/PCM
- DTC U0111: Gauge Control Module Lost Communication With Motor Control Module (BATT message)
- DTC U0122: Gauge Control Module Lost Communication With VSA Modulator-Control Unit
- DTC U0127: Gauge Control Module Lost Communication With TPMS Control Unit (TPMS message)
- DTC U0131: Gauge Control Module Lost Communication With EPS Unit
- DTC U0151: Gauge Control Module Lost Communication With SRS Unit
- DTC U1281: Lost Communication With MICU (MICU frame)
- Symptom Troubleshooting Index
- Symptom Troubleshooting
- Gauge Control Module Input Test
- Multi-Information Switch Test/Replacement
- 3-Mode Switch Test/Replacement
- km/h, mph Change Switch Test/Replacement
- Rewriting the ODO Data and Transferring the Maintenance Minder™ Data to a New Gauge Control Module
- Gauge Control Module Replacement
- Outside Air Temperature Indicator Calibration
- Resetting the Lifetime Points