LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Hood >> Hood Release Handle Replacement

Hood Release Handle Replacement

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the body.
  • Take care not to kink the cable.
  1. Remove the kick panel, driver's side (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
  2. Remove the bolts, then remove the hood release handle (A).
    Fig 1: Hood Release Handle And Hood Opener Cable With Bolt And Torque Specifications
    G06953523Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the hood opener cable (B) from the hood release handle.
  4. Install the hood release handle in the reverse order of removal, and note these items:
    • Make sure the hood opener cable is connected properly.
    • Make sure the hood opens properly.
scientia non olet · About LEMON Manuals