LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Washer Motor Test

Washer Motor Test

  1. Remove the right front inner fender (see FRONT INNER FENDER REPLACEMENT ).
  2. Disconnect the 2P connector (A) from the washer motor (B).
    NOTE: The illustration shows USA models.
    Fig 1: Identifying 2P Connector And Washer Motor
    G06954084Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Test the motor by connecting battery power to terminal No. 1 and ground to the terminal No. 2 of the washer motor. The motor should run.
    • If the motor does not run or fails to run smoothly, replace it.
    • If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.
scientia non olet · About LEMON Manuals