Brake Booster Replacement

Remove the master cylinder (see MASTER CYLINDER REPLACEMENT ).
Disconnect the brake booster vacuum hose (A) from the brake booster (B).

Fig 1: Identifying Brake Booster Vacuum Hose And Valve
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the lock pin (A) and the clevis pin (B), then disconnect the yoke from the brake pedal.

Fig 2: Lock Pin, Joint Pin And Brake Booster Mounting Nuts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the brake booster mounting nuts (C).
Pull the brake booster (A) forward, and remove it from the engine compartment.
NOTE:
- Be careful not to damage the brake booster mounting surfaces and the threads on the booster studs.
- Be careful not to bend or damage the brake lines or other components hoses and lines.
Fig 3: Pulling Brake Booster
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the brake booster in the reverse order of removal, and note these items:
- Install the master cylinder after installing the brake booster (see MASTER CYLINDER REPLACEMENT ).
- Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT ).
- Bleed the brake system (see BRAKE SYSTEM BLEEDING ).