LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Ridgeline RTL >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Cylinder Head >> Crankshaft Pulley Removal and Installation >> Removal

Crankshaft Pulley Removal and Installation: Removal

  1. Raise the vehicle on the lift.
  2. Remove the right front wheel.
  3. Remove the front splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
  4. Remove the drive belt (see DRIVE BELT INSPECTION ).
  5. Hold the pulley with the holder handle (A) and the holder attachment, 50 mm, offset (B).
    Fig 1: Holding Pulley With Holder Handle And Holder
    G05964012Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the bolt with a heavy duty 19 mm socket (C) and a breaker bar, then remove the crankshaft pulley.
scientia non olet · About LEMON Manuals