DTC B1152: Gauge Control Module Internal Error (EEPROM error)
NOTE:
If you are troubleshooting multiple DTC's, be sure to follow the instruction in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
Is DTC B1152 indicated?
YES - Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).
NO - Intermittent failure, the gauge control module is OK at this time.