LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Controls - Self-Diagnostics - 2.2L) >> Diagnostic Trouble Code Identification >> DTC P0351-P0352: Ignition Coil "A" Or "B" Primary/Secondary Circuit Malfunction >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2000 Isuzu Rodeo and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform On-Board Diagnostic II (OBD-II) system check. See SELF-DIAGNOSTICS - INTRODUCTION article. Go to next step.
  2. Check ignition control module for poor connection or damaged terminals. If a problem is found, repair as necessary. Retest system. If no problem is found, go to next step.
  3. Check PCM connector for poor connection or damaged terminals. If a problem is found, repair as necessary. Retest system. If no problem is found, go to next step.
  4. Turn ignition off. Disconnect harness from PCM and ignition control module. Check ignition control circuit for an open or shorted condition. If a problem is found, repair as necessary. Retest system. If no problem is found, go to next step.
  5. Replace ignition control module. Retest system. If problem still exists, go to next step.
  6. Replace and reprogram PCM using required equipment. See PROGRAMMING . Retest system.
scientia non olet · About LEMON Manuals