LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Disc & Drum) >> Removal & Installation >> Rear Disc Brake Pads >> Installation

Rear Disc Brake Pads: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, 2001 Honda Passport, 2000 Isuzu Rodeo, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Replace brake pads if linning thickness is less than .039" (1.0 mm). Install NEW pad clips and shims. Apply Silicone grease to caliper sliding surfaces.
  2. Used pads must be installed to original position. Install pads to caliper support, with wear indicators facing lower side of support bracket. Check parking brake adjustment. See PARKING BRAKE (REAR DISC)  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals