Removal & Installation (2WD)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Isuzu Rodeo Sport, 2001 Isuzu Rodeo, 2001 Honda Passport, 2000 Isuzu Rodeo, and 2000 Isuzu Amigo. However, it is still accessible from the selected car via links, so may be relevant.
Raise and support vehicle. Remove front wheels. Remove caliper and set aside. Remove hub cap and lock washer. Using Hub Nut Wrench (J-36827), remove hub nut. See Figure . Remove outer bearing and rotor. To install, reverse removal procedure. Adjust wheel bearing preload. See WHEEL BEARING PRELOAD under ADJUSTMENTS.