LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2000 >> CR-V SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Disc & Drum) >> Bleeding Brake System >> Bleeding Procedure >> Calipers & Wheel Cylinders (Manual Bleeding)

Calipers & Wheel Cylinders (Manual Bleeding)

WARNING: This page is about a different car, the 2000 Isuzu Hombre and 1999 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean master cylinder cap and surrounding area, and then remove cap. Fill master cylinder. Install clear vinyl bleed hose onto first wheel cylinder or caliper bleed screw to be serviced. See BRAKELINE BLEEDING SEQUENCE  table. Place other end of hose in clean transparent container.
  2. Partially fill container with clean brake fluid so end of hose is submerged in fluid. Slowly pump brake pedal 3 times and hold depressed. Loosen bleed screw until fluid flows through hose.
  3. Close bleed screw, and then release pedal. Pump pedal slowly several times to push air toward wheel cylinders or calipers. Repeat procedure until flow of brake fluid is clear and bubble free. Repeat procedure for each wheel.
scientia non olet · About LEMON Manuals