Calipers & Wheel Cylinders (Pressure Bleeding)
WARNING: This page is about a different car, the 2000 Isuzu Hombre and 1999 Isuzu Hombre. However, it is still accessible from the selected car via links, so may be relevant.
- Clean master cylinder cap and surrounding area, and then remove cap. With pressure tank at least 1/2 full, connect tank to master cylinder using appropriate adapter(s).
- Attach bleed hose to first wheel cylinder or caliper bleed screw to be serviced. See BRAKELINE BLEEDING SEQUENCE table. Place other end of hose in clean transparent container. Partially fill container with clean brake fluid until end of hose is submerged in fluid.
- Open release valve on pressure tank. Open bleed screw, noting fluid flow. When fluid flowing into container is clear and bubble free, close bleed screw securely.
- Finish bleeding system in the same manner using correct sequence. Close release valve, and then remove pressure tank from master cylinder. Check fluid level of master cylinder reservoir.
BRAKELINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| All Models | RR, LR, RF, LF |