LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1994 >> Tracker Base, 1.6 6, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.6L 4-CYL - VINS [U,6] >> Removal & Installation >> Cylinder Head >> Inspection (All Models)

Inspection (All Models)

  1. Inspect cylinder head surface for warpage. Inspect cylinder head manifold seating surfaces for warpage. Replace cylinder head if warpage cannot be corrected by surfacing. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS.
  2. Inspect cylinder block deck surface for warpage. Resurface cylinder block if warpage exceeds specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
  3. On 16-valve, inspect cylinder head oil jet for obstructions. Oil jet is located at timing belt end of head in head-to-block mating surface. See Figure. Tighten oil jet to 44 INCH lbs. (5 N.m).
CAUTION: Install cylinder head gasket with TOP facing away from cylinder block and positioned at crankshaft pulley end of cylinder block.
scientia non olet · About LEMON Manuals