LEMON Manuals: Even more car manuals for everyone
Home >> Geo >> 1990 >> Metro LSi, 2D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (1.3L 4-CYL - VIN [3] & 1.6L 4-CYL - VIN [0]) >> Removal & Installation >> Cylinder Head >> Removal (Sidekick & Swift)

Removal (Sidekick & Swift)

WARNING: This page is about a different car, the 1992 Suzuki Swift, 1992 Suzuki Sidekick, and 1992 Suzuki Samurai. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION. Label and remove hoses, lines and electrical connectors for intake and exhaust manifold removal. Disconnect exhaust pipe from manifold.
  2. Removing exhaust and intake manifolds is not necessary yet. Remove timing belt. See TIMING BELT  under REMOVAL & INSTALLATION. Remove air conditioner compressor and/or alternator adjusting arm from cylinder head (if equipped).
  3. Loosen cylinder head bolts in reverse order of tightening sequence. See Figure . Loosen head bolts in 2 or 3 steps to prevent cylinder head warpage. Remove bolts and cylinder head with intake and exhaust manifolds.
scientia non olet · About LEMON Manuals