TEC (Tooth Error Correction) Learning

WARNING: This page is about a different variant/trim than selected.

Perform TEC Learning according to below procedure.
- TEC Learning method
- TEC Learning will be completed with fuel cut in a range of over 2, 000 RPM for more than 10 seconds.
Start the engine.
Operate the vehicle within Conditions for setting DTC in General Information.
Has the same DTC been found?
YES
- Go to "VISUALLY CHECK CKPS AND TARGET WHEEL " procedure.
NO
- Repair or replace as necessary. go to "VERIFICATION OF VEHICLE REPAIR " procedure.