Check short to ground in CAN BUS
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ECM, smart junction box (gateway) connector.
- Check resistance between P-CAN HIGH terminal of ECM Connector and chassis ground. (CAN HIGH line)
- Check resistance between P-CAN LOW terminal of ECM Connector and chassis ground. (CAN LOW line)
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "CHECK SHORT TO BATTERY IN CAN BUS ".
NO
- Repair short to ground in circuit and go to "VERIFICATION OF VEHICLE REPAIR ".