Check short to battery in CAN BUS
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ECM, smart junction box (gateway) connector.
- IG "ON"
- Measure the voltage between P-CAN HIGH terminal of ECM Connector and chassis ground. (CAN HIGH line)
- Measure the voltage between P-CAN LOW terminal of ECM Connector and chassis ground. (CAN LOW line)
Specification: 0.0V~0.1V
- Is the measured voltage within specification?
YES
- Go to "Check CAN BUS continuity" as follows.
NO
- Repair short to battery and go to "VERIFICATION OF VEHICLE REPAIR ".