LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2022 >> Hummer EV >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Pickup Box Endgate Replacement >> Installation Procedure

Installation Procedure

  1. GM5830122Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, install the pickup box endgate (1).

  2. GM6053699Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Pickup Box Endgate Hinge Bolt (1) - Install and tighten - Fastener Specifications 

  3. GM5830142Courtesy of GENERAL MOTORS COMPANY

    Endgate Cable- Left Side and Right Side (2) - Install [2x]

  4. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
    2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Remove loose debris from internal and external threads using compressed air.
    4. Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers 
  5. Pickup Box Endgate Latch Bolt- Left Side and Right Side (1) - Install and tighten [2x] - Fastener Specifications 
  6. Close the endgate
  7. Connect the electrical connector and install the wiring harness retainers.
scientia non olet · About LEMON Manuals